| Device Properties |
| Property name |
Property type |
Description |
| BoardType |
Tango::DEV_USHORT |
The board type ( the possible values are SAI_2005, SAI_2010). |
| BoardNum |
Tango::DEV_USHORT |
The number of the board in the cPCI chassis (between 0 and 7). |
| InputRange0 |
Tango::DEV_USHORT |
The input range for channel 0 ( possible values are B_10, B_5, B_2_5, B_1_25, U_10, U_5, U_2_5, U_1_25 ). |
| InputRange1 |
Tango::DEV_USHORT |
The input range for channel 1 ( possible values are B_10, B_5, B_2_5, B_1_25, U_10, U_5, U_2_5, U_1_25 ). |
| InputRange2 |
Tango::DEV_USHORT |
The input range for channel 2 ( possible values are B_10, B_5, B_2_5, B_1_25, U_10, U_5, U_2_5, U_1_25 ). |
| InputRange3 |
Tango::DEV_USHORT |
The input range for channel 3 ( possible values are B_10, B_5, B_2_5, B_1_25, U_10, U_5, U_2_5, U_1_25 ). |
| Timeout |
Tango::DEV_DOUBLE |
The time to wait for incoming data before generating a timout. In seconds. |
| TriggerMode |
Tango::DEV_USHORT |
The trigger mode.
Can be a POST trigger and data is acquired just after the received trigger.
Can be a DELAY trigger and data is acquired after a certain delay. |
| TriggerSource |
Tango::DEV_USHORT |
To choose analog (ATRIG) or digital trigger(DTRIG). |
| ATRIGSelection |
Tango::DEV_USHORT |
To select the type of analog trigger.
The trigger can be generated when the analog trigger passes below a level
or above a level.
The possible values are BELOWand ABOVE. |
| ATRIGLevel |
Tango::DEV_DOUBLE |
The level of the analog trigger in volts. |
| DTRIGPolarity |
Tango::DEV_USHORT |
The digital level polarity.
It can be detected on rising edge or falling edge.
The possible values are RISING or FALLING. |
| Delay |
Tango::DEV_DOUBLE |
The delay after a Delay trigger in seconds. |
| ConversionSource |
Tango::DEV_USHORT |
Set the AI conversion signal source (i.e. DAC sampling source).
Use one of the following: INTERNAL, EXTSAMPLING. |
